The Insigmia ues the auto learn system so the tool is no use to you,
you need to replace the standard valve with the correct auto learn one then carry out the auto learn proceedure
Auto Learn („UJN“)
ď‚· Prior to carrying out a learn drive, the vehicle has to be left standing still for 20 minutes with ignition off (sensors go into sleep mode)
ď‚· Perform a learn drive of app. 10 minutes in a speed range between 25 to 60 mph.
ď‚· As a rule, sensors are recognized within a few minutes and the tyre pressures are displayed in the Driver Information Centre (DIC)
ď‚· For vehicles from model year 2014, the correct allocation of sensors must be done within 10 minutes, otherwise TPMS telltale is flashing after this time and fault codes must be checked (Adam, Cascada)
ď‚· On vehicles before model year 2014, it may take up to 20 minutes, until a fault is detected. If within 15 consecutive ignition cycles no successful learning process could be performed, the message "Winter Mode" will appear in the Driver Information Centre (DIC) and dashes (---) will be displayed instead of the pressure.
If the winter mode is detected, TPMS is disabled