Vauxhall Owners Network Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi!

I'm in the process of changing my injectors on my 2010 1.7CDTi Combo with the Z17DTH engine.

Do anyone know the correct torque value for the M8(?) bolts that goes through the "fork" holding the injectors ? Also looking for torque values for the valve cover bolts.


Alternatively is there a workshop manual for this engine somewhere where torque values are specified? I've tried googling but had no luck finding anything useful.

99771
 

·
Well-known member
Joined
·
15,922 Posts
Look for TIS2000, which is essentially the Vauxhall workshop manual and gives you everything you need.
Easy enough to find online or there are sellers on eBay.
 
  • Like
Reactions: Joppe

·
Registered
Z12XE / Z19DT / B16DTH
Joined
·
392 Posts
Z17DTH Injector Clamps:

Injector Clamp Stage 1: 40 Nm
Injector Clamp Stage 2: Slacken Bolt
Injector Clamp Stage 3: 32 Nm

Camshaft Cover Bolts: 10 Nm

From my Diesel Haynes Manual (y)

 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
Look for TIS2000, which is essentially the Vauxhall workshop manual and gives you everything you need.
Easy enough to find online or there are sellers on eBay.
Thanx (y) Did'nt know there was a TIS for Opel as well. Will definetily install.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
Z17DTH Injector Clamps:

Injector Clamp Stage 1: 40 Nm
Injector Clamp Stage 2: Slacken Bolt
Injector Clamp Stage 3: 32 Nm

Camshaft Cover Bolts: 10 Nm

From my Diesel Haynes Manual (y)

Thank you Sir! Exactly what I needed :giggle: Superb!
 
1 - 5 of 5 Posts
Top