Vauxhall Owners Network Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
So I got a new knockoff opcom running Vauxcom 12 something. I managed to run the automatic model detection once but that's it everything else results in interface error (is it powered I think the error says) but the ignition is on and if I unplug usb then the opcom devices power light stays lit so I know theres power there. One thing I noticed was the 2 center pins (grounds) are slightly longer than the rest, and the connector seems to rock rather than fit snug any ideas.

Zafira b 2011
 

·
Well-known member
Joined
·
13,715 Posts
You are running W10.
W10 has updated the driver, which is why it no longer works.
Correct?
 

·
Worn Out Member
Joined
·
6,444 Posts
In device manager,check which version driver it's running then click on the advanced tab
and make sure "check vcp" isn't ticked
 
1 - 5 of 5 Posts
Top