Vauxhall Owners Network Forum banner
z22yh
1-6 of 7 Results
  1. Car Audio / Electrical / Security / Diagnostic Rel
    Hi all Im having an issue with my 2004 Vauxhall Signum 2.2 Direct injection. It will not crank at all I will go deep into details, the car was daily driven until mid 2019 when the original owner hit a pot hole in his driveway(wales for you) he parked up outside home and when he came back to...
  2. Large Vauxhalls
    Vectra 2.2 direct petrol Z22YH Problem: When started from cold, sounding like a diesel under the bonnet, then when revved it will cut out, the engine will not rev over 1500rpm before cutting out. Car will start straight back up but runs rough. Therefore car is not drivable. It was juddering...
  3. Large Vauxhalls
    Hi guys, I'm getting a P0341 cam circuit fault code after installing new timing chains. The power and ground wires to the sensor are good with no drop outs. I'm getting nothing on the signal wire with the engine rotating, but am able to do a bypass and create a signal. It's as though there's...
  4. Large Vauxhalls
    Hi all, Started my car yesterday and it sounded very noisy and obviously something wrong, so i stopped it straight away, now when i try to start it the engine just turns over but dont fire. I am not sure why i think its the cam chain but knowing the chain is loose and the noise it made the...
  5. Large Vauxhalls
    Hi everyone, I have a problem that's come on quite quickly with my veccy. I have op-com code read the ecu with error code p0301, cylinder 1 misfire. The engine starts fine and some times there seems to be very little or no misfire when idling, until i drive it about 100 yards, Then the...
  6. Large Vauxhalls
    Hi folks! Ok, got a rather odd one here! I've just recently taken ownership of a Vectra c with the z22yh Ecotec engine. It was going about 5 miles before overheating, so I did a few checks. What I'm noticing is that the top radiator hose gets really hot and pressurises, whilst the bottom hose...
1-6 of 7 Results
Top